Shopping Cart

0 item(s) in cart/ total: $0    view cart
Fuel Injector Clinic High Impedance Injectors 4G63T DSM EVO 8/9

Fuel Injector Clinic High Impedance Injectors 4G63T DSM EVO 8/9

Your Price: $338.10
Retail Price:$345.00
Your Savings:$6.90(2%)
Part Number:FIC IS126-

Choose Options

Flow Rate
650cc
775cc [+$31.00]
900cc [+$80.00]
1100cc [+$166.00]
Additional Options
Resistor Pack Delete Plug [+$22.00]
PNP Plug Adapters [+$45.00]

Mitsubishi DSM/Evo High Impedance Ball & Seat Injectors. Latest injector technology.  Great linearity and short pulse width repeatability. Requires pigtails PGT USC4 or P&Play adaptors PADPUtoD4. Resistor pack removal recommended.

Fuel Injector Clinic injector sets are all precisely flow matched to within less than 2%. Each injector within each set is individually numbered and results for each injector are listed on a detailed flow sheet included with the set. Dynamic flow matching is used only on injector sets where the additional time and cost are justified by the corresponding benefits gained during the tuning process.

Fuel Injector Clinic injectors are flow tested and rated at 43.5psi (3Bar) at 75ºF average fuel temperature using CF-16B calibration fluid.

The superior spray pattern and fuel atomization make these injectors easy to tune and provide great drivability.

Fuel Injector Clinic injectors are set up to fit and include all o-rings needed to fit the factory application for the listed vehicle. For aftermarket or other unusual setups please contact us to make sure you receive injectors that fit properly.

Every injector is covered against failure caused by defects in original manufacture by our 12 month warranty.

Fuel Injector Clinic injectors use the factory electrical connector or include solder-in pigtails. You can purchase adaptor plug-n-play harnesses to avoid cutting your stock harness as an optional extra.

This injector set contains high impedance injectors matched to the saturated injector signal generated by this vehicles OEM ECU (OR is suitable for use with an aftermarket ECU made or set up for high impedance injectors).

This set of injectors requires you to change the injector plug on the wiring harness in your car. This can be done by soldering in the pigtails (included with purchase) to replace the plugs currently on your harness, or you can choose to purchase the optional plug-n-play adaptors which will convert from the type of plugs on these injectors to the plugs on your harness without any need for cutting or soldering.

Related Items

Recently Viewed Items